Question Set

1. According to Indian standards, the diameter of rivet hole is made larger than the basic size of rivet by





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A circular disc of copper has a symmetrical hole at its center. The disc is uniformly heated. The diameter of the hole will?....
QA->R is taller than X, but shorter than Z, Q is taller than Z, Y is taller than X, but shorter than R, Who is the shortest?....
QA->In Kiran’s opinion, his weight is greater than 65 kg but less than 72 kg. His brother does not agree with Kiran and he thinks that Kiran’s weight is greater than 60 kg but less than 70 kg. His mother’s view is that his weight cannot be greater than 68 kg. If all are them are correct in their estimation, what is the average of different probable weights of Kiran?....
QA->In an examination of mathematics Rajesh obtained more marks than the total marks obtained by Rahim and Sabu. The total marks obtained by Rahim and Saji was more than the Rajesh’s. Rajesh obtained more marks than Saji, Reenu obtained more marks than Rajesh. Who amongst them obtained the....
QA->Rekha is taller than Asha. Deepa is as tall as Priti. Supriya is shorter than Veena. Sita is taller than Asha. Veena is shorter than Deepa. Who is the shortest ?....
MCQ->According to Indian standards, the diameter of rivet hole is made larger than the basic size of rivet by....
MCQ->Diameter of a rivet hole is made larger than the diameter of the rivet by....
MCQ->Consider the following statements: 1. Bureau of Indian Standards was set up as a statutory organization under the Bureau of Indian Standards Act, 1986 2. Bureau of Indian Standards had taken over the assets and liabilities of the Indian Standards Institution (ISI) that came into existence in 1947. Which among the above statements is / are correct?....
MCQ->In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole)....
MCQ->In order to avoid tearing off the plate at an edge, the distance from the centre of the rivet hole to the nearest edge of the plate (i.e. margin) should be (where d = Diameter of rivet hole in mm)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution