Toggle navigation
Home
KPSC Previous Question Papers
Article Category
kerala psc
upsc
General
Popular Pages
Multiple Choice Question in aptitude-area
Multiple Choice Question in non-verbal-reasoning-grouping-of-images
Multiple Choice Question in aptitude-compound-interest
Multiple Choice Question in engineering-mechanics-kinetics-of-a-particle-impulse-and-momentum
Multiple Choice Question in electronic-devices-bipolar-junction-transistors
Multiple Choice Question in 035/2016
Multiple Choice Question in database-database-redesign
Question Answer in malayalam-kerala-psc-questions
Multiple Choice Question in malayalam-kerala-psc-questions
Multiple Choice Question in current-affairs-2017-03-05
Question Answer in KERALA PSC
Multiple Choice Question in KERALA PSC
Question Answer Bank
Multiple Choice Question Bank
Question Answer Category
Multiple Choice Question Category
Home
->
Multiple Choice Questions
Question Set
mechanical engineering strength of materials
1. A section of beam is said to be in pure bending, if it is subjected to
(A): constant bending moment and constant shear force
(B): constant bending moment and zero shear force
(C): constant shear force and zero bending moment
(D): none of the above
Previous Question
Show Answer
Next Question
Add Tags
Report Error
Show Marks
Ask Your Doubts Here
Type in
(Press Ctrl+g to toggle between English and the chosen language)
Post reply
Comments
Show Similar Question And Answers
QA->Pure water is a bad conductor of electricity because pure water does not dissociate into?....
QA->In a certain code, "FOP" stands for "OLD IS GOLD", POT stands for "GOLD IS PURE" and POM stands for GOLD IS COSTLY. Then how will "PURE OLD GOLD IS COSTLY" be written?....
QA->ബീം (BEAM-Bigelow Expandable Activity Module) എന്നാൽ എന്ത് ? ....
QA->First American President who was subjected to impeachment is ?....
QA->Which mirror is to be used to obtain a parallel beam of light from a small lamp?....
MCQ->A simply supported beam of uniform cross-section is subjected to a maximum bending moment of 2.25 t.m. If it has rectangular cross-section with width 15 cm and depth 30 cm, then the maximum bending stress induced in the beam will be....
MCQ->A cast iron T section beam is subjected to pure bending. For maximum compressive stress to be three times the maximum tensile stress, centre of gravity of the section from flange side is....
MCQ->A section of beam is said to be in pure bending, if it is subjected to....
MCQ->A cantilever beam 'A' with rectangular cross-section is subjected to a concentrated load at its free end. If width and depth of another cantilever beam 'B' are twice those of beam A, then the deflection at free end of the beam 'B' as compared to that of 'A' will be....
MCQ->In a pre-stressed concrete beam of span 6 m and section 300 mm x 500 mm,the pre-stressing tendons are located along the longitudinal centroidal axis,with an effective pres-stressing force of 900kN.If the beam is subjected to a uniformly distributed load of 15 kN/m including the self weight of the beam,the top and bottom extreme fibre stresses in concrete at the mid span section are respectively....
×
×
Type The Issue
×
Your Marks
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...
Privacy
|
Terms And Conditions
Question ANSWER With Solution