Question Set

1. Which is the most suitable joint for the pipes, with are laid submerged under water, where the bottom of the river bed is uneven ?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Water pipes break in winter in cold regions due to?....
QA->The surface of water in a lake is just slowly being frozen. What is the temperature of water at the bottom of the lake?....
QA->A large tank having a small hole at the bottom is filled with water to a height h. if the stream of water coming out of the hole is directed vertically upwards it will?....
QA->A motorboat went the river for 14 km and then up the river for 9 km. If took a total of 5 hrs the entire journey. Find the speed of the river flow if the speed of the boat in still water is 5 km/h.....
QA->A motorboat went the river for 14 km and then up the river for 9 km. If took a total of 5 hrs the entire journey. Find the speed of the river flow if the speed of the boat in still water is 5 km/h.....
MCQ->Which is the most suitable joint for the pipes, with are laid submerged under water, where the bottom of the river bed is uneven ?....
MCQ->The following statements relate to the pressure exerted by a fluid on a Submerged curved surface : 1. The vertical component of hydrostatic force acting on a submerged curved surface acts through the centre of volume of the fluid directly above the submerged area. 2. The horizontal component of the force acting on a curved surface is the hydrostatic force acting on the vertical projection of the curved surface. 3. The resultant force on a curved surface acts on the bottom of th6 curved surface. Of these statements :....
MCQ->A bed of spherical particles (specific gravity 2.5) of uniform size 1500 μm is 0.5 m in diameter and 0.5 m high. In packed bed state, the porosity may be taken as 0.4. Ergun's equation for the above fluid-particle system (in SI units) is given below : Δ P/L = 375 x 103 VOM + 10.94 x 106 V2OM (SI units) If water is to be used as the fluidising medium, in actual operation, the above bed has a height = 1 m. What is the porosity of the fluidised bed ?....
MCQ->Bed pressure drop in an air fluidised bed of catalyst particles (ρp = 200 kg/m3, Dp = 0.05 cm) of 60 cm bed depth and bed porosity of 0.5 expressed in cm of water (manometer) is....
MCQ->Statement: Incessant rain for the past several days has posed the problem of overflowing and flood as the river bed is full of silt and mud. Courses of Action: The people residing near the river should be shifted to a safe place. The people should be made aware about the imminent danger over radio/television. The silt and mud from the river bed should be cleared immediately after the receding of the water level.

....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution