Question Set

1. A photo electric device in which the resistance of the metal is directly proportional to the light striking on it, is known as photo-conductive cell. Photoelectric transducers are used for the measurement of those parameters, which can be used to produce variation in





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->In the photoelectric effect, the number of photoelectrons emitted is proportional to?....
QA->In photoelectric effect the number of photoelectrons emitted is proportional to?....
QA->When yellow light is incident on a surface no electrons are emitted while green light can emit. If the red light is incident on the surface then?....
QA->Photoelectric effect can be explained by assuming that light?....
QA->What is directly proportional to the energy of a photon?....
MCQ->A photo electric device in which the resistance of the metal is directly proportional to the light striking on it, is known as photo-conductive cell. Photoelectric transducers are used for the measurement of those parameters, which can be used to produce variation in....
MCQ->Which of the following variations of magnetic declination are correctly matched ? 1. Diurnal variation..........Variation whose time period varies from 100-350 years 2. Annual variation.........Annual rate of change of secular variation 3. Secular variaiion..........Variation of declination periodic in character 4. Irregular variation.........Caused due to magnetic storms in earth's magnetic field Select the correct answer using the codes given below : ....
MCQ->Assertion (A): The amount of photoelectric emission depends on the intensity of incident light. Reason (R): Photo electric emission can occur only if frequency of incident light is less than threshold frequency.

....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->Consider the following statements: In the case of space wave propagation, the signal strength at the receiver is Directly proportional to transmitter and receiver heights.Inversely proportional to distance between transmitter and receiver.Directly proportional to frequency. Which of the above statements is/are correct?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution