Question Set

1. A pile of 0.50 m diameter and of length 10 m is embedded in a deposit of clay. The un-drained strength parameters of the clay are cohesion = 60 kN/m2 and the angle in internal friction = 0. The skin friction capacity (kN) of the pile for an adhesion factor of 0.6, is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The complete reflection of a light ray reaching an interface with a less dense medium when the angle of incidence exceeds the critical angle is called Total Internal?....
QA->The angle of elevation of the top of a hill at the foot of a tower is 60° and the angle of elevation of the top of the tower from the foot of the hill is 30°. If the tower is 50 m high, the height of the hill is—....
QA->A man with a dark skin; in comparison with a man with a white skin; What will experience?....
QA->A man with a dark skin, in comparison with a man with a white skin, What will experience?....
QA->Our skin; when exposed to excess sunlight; becomes dark. This is because our skin pigments called?....
MCQ->A pile of 0.50 m diameter and of length 10 m is embedded in a deposit of clay. The un-drained strength parameters of the clay are cohesion = 60 kN/m2 and the angle in internal friction = 0. The skin friction capacity (kN) of the pile for an adhesion factor of 0.6, is....
MCQ->A 30 cm diameter friction pile is embedded 10 m into a homogeneous consolidated deposit. Unit adhesion developed between clay and pile shaft is 4 t/m2 and adhesion factor is 0.7. The safe load for factor of safety 2.5 will be....
MCQ->Consider the following statements pertaining to a pile group and a single pile at failure : 1. In loose and medium dense sands, the failure load per pile in a group will generally be greater than the failure load for a single pile. 2. In cohesive soils, the failure load per pile in a group will be greater than failure load for a single pile. 3. For piles driven in dense sands, the failure load per pile in a group is greater than the failure load for a single pile. 4. When the pile spacing is greater than 10 times the pile diameter, the failure loads per pile in a group and forly same in both sands and clays. Of these statements :....
MCQ->Two piles, one a bored cast-in-situ pile and another a precast driven pile, both of same length and diameter are constructed in a loose sand deposit. If the bearing capacity of the bored pile is Q1, and that of the precast driven pile is Q2, then which of the following is correct ?....
MCQ->Consider the following field tests : 1. Vertical pile load test 2. Cyclic pile load test 3. Lateral pile load test 4. Instrumented test pile While estimating the load carrying capacity of a pile, the tests that can be used for separating the skin resistance from point resistance, would include....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution