When transistor is used as a switch __________ is defined as the interval which elapses between the transition of input waveform and the time when to transition to 90% of Ic(sat). ?->(Show Answer!)

Question Set

1. When transistor is used as a switch __________ is defined as the interval which elapses between the transition of input waveform and the time when to transition to 90% of Ic(sat).

Ask Your Doubts Here

Comments

Show Similar Question And Answers

QA->A semiconductor device used to amplify or switch electronic signals and electrical . power?....

QA->The interval between two consecutive sessions of Lok Sabha shall be less than ........ months?....

QA->A maximum interval of ___ can elapse between two sessions of a State Legislative Assembly.?....

QA->What is the interval between two tides?....

QA->How is the difference between visible exports and visible imports defined?....

MCQ->When transistor is used as a switch __________ is defined as the interval which elapses between the transition of input waveform and the time when to transition to 90% of Ic(sat).....

MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....

MCQ->Consider the following statements: For a master-slave J-K flip-flop, the toggle frequency is the maximum clock frequency at which the flip-flop will toggle reliably.the data input must precede the clock triggering edge transition time by time minimum time.the data input must remain fixed for a given time after, the clock triggering edge transition time for reliable operation.propagation delay time is equal to the rise time and fall time of the data. Which of the above statements is/are correct?....

MCQ->Which of the following sentences are correct about a switch loop in a C program? 1: switch is useful when we wish to check the value of variable against a particular set of values. 2: switch is useful when we wish to check whether a value falls in different ranges. 3: Compiler implements a jump table for cases used in switch. 4: It is not necessary to use a break in every switch statement.....

MCQ->__________ switch, a T flip-flop is used as __________ switch, a T flip-flop is used as switch....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution