Question Set

1. Consider the following units sec-1rad2/sec2secΩ The units of , RC and are respectively





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.07 am
    has units of seconds. Therefore, has units of sec-1. has units of rad/sec. Therefore has units of rad2/sec2, RC is a time constant and has units of sec. has units of ohms.
Show Similar Question And Answers
QA->.If three resistances 6 ohm,4 ohm and 3 ohm are connected in parallel,what will be the total resistance?....
QA->Present ages of Kiran and Syam are in the ratio of 5:4 respectively. Three years hence, the ratio of their ages will become 11:9 respectively. What is Syam"s present age in years?....
QA->Present ages of Kiran and Syam are in the ratio of 5 : 4 respectively. Three years hence, the ratio of their ages will become 11 : 9 respectively. What is Syam"s present age in years?....
QA->What is the number of basic units in the International System of Units?....
QA->The Units which are derived from fundamental units?....
MCQ->Consider the following units sec-1rad2/sec2secΩ The units of , RC and are respectively....
MCQ->The frame of electric motor is connected to three plates having earthing resistance of 10 Ω, 20 Ω and 30 Ω respectively. The materials of the three plates are copper, aluminium and iron respectively. The percentage of energy dissipated by 10 Ω earthing plate....
MCQ->Consider 49 cascaded amplifiers having individual rise time as 2 n sec. 3 n sec. ... 50 n sec. The input waveform rise time is 1 n sec. Then the output signal rise time is given time by (Assume output signal rise time is measured within 10 percent range of the final output signal.)....
MCQ->Which of the following is not a dimension-less group used in catalysis ? (where, D = dispersion co-efficient, cm2 /sec.D1 = diffusion co-efficient; cm2/sec L = length of the reactor, cm t = time, sec, v = volumetric flow rate, cm3/sec . V = volume, cm3.)....
MCQ->A transistor amplifier has poles at s1 = - 0.000245 x 109 rad/sec. s2 = - 0.0748 x 109 rad/sec. s3 = - 0.670 x 109 rad/sec. s4 = - 4.38 x 109 rad/sec. The upper 3 dB frequency of the amplifier will be....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution