Question Set

1. Assertion (A): When the anode current of an SCR starts increasing during turn on process, the anode cathode voltage drop starts decreasing. Reason (R): During turn on the reverse biased junction in SCR breaksdown.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The device used for converting current from a lower voltage to a higher voltage is known as?....
QA->John started from his home and walked 12 km.Then he took a right turn and walked 4 km.Then again,he took a right turn and walked 8 km and finally took another right turn and walked 1 km.How far is he from his home now?....
QA->During the process of electrolytic refining of copper some metals present as impurity settle as anode mud these are?....
QA->Speed of a swimmer when moving in the direction perpendicular to the direction of the current is 16 km/h, speed of the current is 3 km/h. So the speed of the swimmer against the current will be (in km/h):....
QA->A man who can swim 48 m/minute in still water. He swims 200 m against the current and 200 m with the current. If the difference between those two times is 10 minutes, what is the speed of the current?....
MCQ->Assertion (A): When the anode current of an SCR starts increasing during turn on process, the anode cathode voltage drop starts decreasing. Reason (R): During turn on the reverse biased junction in SCR breaksdown.

....
MCQ->Assertion (A): In reverse biased p-n junction, the reverse saturation current is nearly constant if the reverse voltage is less than critical value. Reason (R): The total reverse current is sum of reverse saturation current and surface leakage current.

....
MCQ->Assertion (A): When p-n junction is forward biased, steady current flows. Reason (R): When a p-n junction is forward biased, free electrons cross the junction from n to p and holes from p to n.

....
MCQ->Assertion (A): A BJT can be used as a switch. Reason (R): In forward active mode emitter base junction is forward biased and base collector junction is reverse biased.

....
MCQ->Which of the following conditions must be satisfied for a transistor to remain under saturation? Its collector to base junction should be under forward bias.Its collector to base junction should be under reverse bias.Its emitter to base junction should be under reverse bias.Its emitter to base junction should be under forward bias. Select the correct answer from the codes given below:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution