Question Set

1. In a cold chamber die casting machine, a measured quantity of molten metal is brought in a ladle from the melting pot to a chamber and forced into the closed die-section by applying hydraulic pressure upon the plunger.



Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The oldest rocks in the earth's crust were once molten; and came from deep inside the earth. The molten rock; called magma; spewed out in volcanic eruptions during the earth;s early life and solidified into hard rock's called?....
QA->‘Hydraulic brakes’ and ‘Hydraulic lift’ are devices; why are fluids used in them?....
QA->‘Hydraulic brakes’ and ‘Hydraulic lift’ are devices, why are fluids used in them?....
QA->Which civilisation is also known as the'melting pot of civilisation' ?....
QA->After the attainment of political independence in 1947, Gandhiji felt that the Congress, as a propaganda vehicle and a parliamentary machine, had outlived its usefulness. So to keep the Congress away from unhealthy competition with political parties and communal bodies, Gandhiji towards the end of January 1948 sketched a draft constitution for the Congress to transform itself into ......?....
MCQ->In a cold chamber die casting machine, a measured quantity of molten metal is brought in a ladle from the melting pot to a chamber and forced into the closed die-section by applying hydraulic pressure upon the plunger.....
MCQ->In a die casting method, the molten metal is forced into mould under high pressure.....
MCQ->Solidification time of a molten metal in a casting is proportional to (where, V = volume of metal & A = its surface area ; in the casting)....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->In a cold chamber die casting machine, only non-ferrous alloys with __________ are casted.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution