Question Set

1. What command will permit SMTP mail to only host 1.1.1.1?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

  • By: guest on 02 Jun 2017 01.57 am
    When trying to find the best answer to an access-list question, always check the access-list number and then the protocol. When filtering to an upper-layer protocol, you must use an extended list, numbers 100-199 and 2000-2699. Also, when you filter to an upper-layer protocol, you must use either tcp or udp in the protocol field. If it says ip in the protocol field, you cannot filter to an upper-layer protocol. SMTP uses TCP.
Show Similar Question And Answers
QA->Who described ‘Directive Principles’ as a cheque payable by the bank when able only when the resources of the bank permit?....
QA->If you have a Power point show you created and want to send using E-mail to another teacher you can add the show to your E-mail message as an______....
QA->Command (v)....
QA->To enhance the operational capability of which command, Naval Air Station (NAS) Shibpur will be commissioned as INS Kohassa?....
QA->Name the Air Marshal who has been appoined as the new Strategic Forces Command (SFC) Chief?....
MCQ->What command will permit SMTP mail to only host 1.1.1.1?....
MCQ->What information is displayed by the show hosts command? Temporary DNS entries The names of the routers created using the hostname command The IP addresses of workstations allowed to access the router Permanent name-to-address mappings created using the ip host command The length of time a host has been connected to the router via Telnet....
MCQ->While working with mail command, which command is used to save mail in a separate file?....
MCQ->You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy? Switch(config-if)# ip access-group 10 Switch(config-if)# switchport port-security maximum 1 Switch(config)# access-list 10 permit ip host 1 Switch(config-if)# switchport port-security violation shutdown Switch(config)# mac-address-table secure....
MCQ->What protocol(s) is(are) allowed a user to retrieve her/his mail from the mail server to her/his mail reader?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution