1. Which metal is added to gold for making ornaments?

Answer: Copper

Reply

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Which metal is added to gold for making ornaments?....
QA->The metal used with gold for making ornaments?....
QA->In a certain code, "FOP" stands for "OLD IS GOLD", POT stands for "GOLD IS PURE" and POM stands for GOLD IS COSTLY. Then how will "PURE OLD GOLD IS COSTLY" be written?....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->Which carat of gold is used to make ornaments?....
MCQ->Statements: The Bank of England's move to auction 25 metric tons of gold drew plenty of bidders looking for a bargain, but was criticised by major gold producers worldwide. Conclusions: The Bank of England should not auction gold which it possesses to keep steady international prices of gold. Bidders should quote higher gold prices to retain present value of gold in the international markets.

...
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is...
MCQ->Find the percentage of pure gold in 17 carat gold,if 24 carat gold is 100 % pure gold:...
MCQ->A metal pipe of 1 m diameter contains a fluid having a pressure of 1 N/mm2. If the permissible tensile stress in the metal is 20 N/mm2, then the thickness of the metal required for making the pipe will be...
MCQ->The casting method adopted for ornaments and toys of non-ferrous alloys, is...
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution