1. Alloy used to make rock driller?

Answer: Manganese

Reply

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Tags
Show Similar Question And Answers
QA->Alloy used to make rock driller?....
QA->.Alloy of Tin and Lead are used to make?....
QA->Alloy used to make springs and suspension?....
QA->The oldest rocks in the earth's crust were once molten; and came from deep inside the earth. The molten rock; called magma; spewed out in volcanic eruptions during the earth;s early life and solidified into hard rock's called?....
QA->Where did the Pallava kings make of rock-cut temples?....
MCQ->Consider the following statements with respect to tunnelling methods: 1. Full face excavation is suitable for small size tunnel of short length in compact rock. It is not suitable in urban areas. 2. Heading and Benching method is suitable for soft rock tunnelling of medium size. 3. Drift method is suitable for large tunnels in difficult or incompetent rock. Which of the statements given above are correct ?...
MCQ->With reference to the history of Indian rock-cut architecture, consider the following statements: 1. The caves at Badami are the oldest surviving rock-cut caves in India.2. The Barabar rock-cut caves were originally made for Ajivikas by Emperor Chandragupta Maurya.3. At Ellora, caves were made for different faiths.Which of the statements given above is/are correct?...
MCQ->With reference to the history of Indian rock-cut architecture, consider the following statements: 1. The canves at Badami are the oldest surviving rock-cut caves in India. 2. The Barabar rock-cut caves wre originally made for Ajivikas by Emperor Chandragupta Maurya. 3. At Ellora, caves were made for different faiths. Which of the statements given above is/are correct?...
MCQ->The partial pressure of each constituent present in an alloy is __________ the total vapor pressure exerted by the alloy....
MCQ->A hollow steel shaft of external diameter 100 mm and internal diameter 50 mm is to be replaced by a solid alloy shaft. Assuming the same value of polar modulus for both, the diameter of the solid alloy shaft will be...
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution