Question Set

1. The overall heat transfer coefficient for a shell and tube heat exchanger for clean surface is ‘u_(0)=400(W)/(m^(2)K)’.The fouling factor after one year of operation is found to be ‘hd_(0)=2000’’(W)/(m^(2)K)’.The overall heat transfer coefficient at this time is





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Let a thin capillary tube be replaced with another tube of insufficient length then, we find water?....
QA->“One caste, One religion and One God for man of the same blood and form, there is no difference animals of the same caste alone procreate Viewed thus all humanity belong to one caste”- In which book of Sree Narayana Guru these words can be seen?....
QA->Who exhorted the world famous dictum "One caste, One religion, One clan, One world, One God"?....
QA->A, B and C start at the same time in the same direction to run around a circular stadium. A completes a round in 252 seconds, B in 308 seconds and c in 198 seconds, all starting at the same point. After what time will they again at the starting point ?....
QA->Transfer of heat from hotter region carrying heat to a colder region is called?....
MCQ->The overall heat transfer coefficient for a shell and tube heat exchanger for clean surface is ‘u_(0)=400 (W)/(m^(2)K)’.The fouling factor after one year of operation is found to be ‘hd_(0)=2000’’(W)/(m^(2)K)’.The overall heat transfer coefficient at this time is....
MCQ->The overall heat transfer coefficient for a shell and tube heat exchanger for clean surface is ‘u_(0)=400(W)/(m^(2)K)’.The fouling factor after one year of operation is found to be ‘hd_(0)=2000’’(W)/(m^(2)K)’.The overall heat transfer coefficient at this time is....
MCQ->The overall heat transfer co-efficient for a shell and tube heat exchanger for clean surfaces is U0 = 400 W/m2.K. The fouling factor after one year of operation is found to be hd0 = 2000 W/m2.K. The overall heat transfer co-efficient at this time is....
MCQ->Fouling factor for a heat exchanger is given by (where, U1 = heat transfer co-efficient of dirty surface U2 = heat transfer co-efficient of clean surface)....
MCQ->A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution