Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
In BOF, desiliconisation is a first order reaction. So the silicon content of the metal decreases ?->(Show Answer!)
Question Set

1. In BOF, desiliconisation is a first order reaction. So the silicon content of the metal decreases





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->What is the substance which decreases the rate of a chemical reaction?....
QA->A substance that speeds up a chemical reaction without being consumed itself in the reaction....
QA->If a non-metal is added to the interstitial sites of a metal, then the metal becomes?....
QA->Which metal is extracted by electrolytic reaction method?....
QA->If a stay order has been granted by the High Court in a case, the application of the affected party by such an order shall be disposed of by the High Court within a period of?....
MCQ->In BOF, desiliconisation is a first order reaction. So the silicon content of the metal decreases....
MCQ->Rate constant for a first order reaction does not depend upon reaction time, extent of reaction and the initial concentration of reactants ; but it is a function of reaction temperature. In a chemical reaction, the time required to reduce the concentration of reactant from 100 gm moles/litre to 50 gm moles/litre is same as that required to reduce it from 2 gm moles/litre to 1 gm mole/litre in the same volume. Then the order of this reaction is....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->A chain growth polymerisation reaction consists of three different types of reaction namely initiation reaction, propagation reaction & termination reaction. Chain growth polymerisation reaction is not involved in the manufacture of....
MCQ->Silicon is doped with boron to a concentration of 4 x 1017 atoms/cm3. Assuming the intrinsic carrier concentration of silicon to be 1.5 x 1010/cm3 and the value of to be 25mV at 300K. Compared to undoped silicon, the Fermi level of doped silicon....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution