Question Set

1. A conical tank with a bottom opening of cross-sectional area A is filled with water and is mounted on supports as shown in the figure. What is the force F with which plate X must be pushed up to prevent water from leaking ? Assume that the density of air is negligible as compared to the density of water ρL.





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->A large tank having a small hole at the bottom is filled with water to a height h. if the stream of water coming out of the hole is directed vertically upwards it will?....
QA->The pressure at the bottom of a liquid tank does not depend on which area?....
QA->The quantity of water in a cistern doubles every minute. It gets filled in 60 minutes. In how many minutes will it be half - filled?....
QA->Most fish do not sink in water because of the presence of: swim bladder; air bladder; air sacs; air in spongy bones?....
QA->If the central portion of a convex lens is wrapped in black paper as shown in the figure?....
MCQ->A conical tank with a bottom opening of cross-sectional area A is filled with water and is mounted on supports as shown in the figure. What is the force F with which plate X must be pushed up to prevent water from leaking ? Assume that the density of air is negligible as compared to the density of water ρL. ....
MCQ->Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)....
MCQ->Water is entering a storage tank at a temperature T0 and flow rate Q0 and leaving at a flow rate Q and temperature T. There are negligible heat losses in the tank. The area of cross-section of the tank is A0. The model that describes the dynamic variation of temperature of water in the tank with time is given as : ....
MCQ->A parallel plate capacitor has area of plate A and plate separation d. Its capacitance is C. A metallic plate P of area A and negligible thickness is added as shown in Figure. The new value of capacitance is ....
MCQ->A free jet of water of cross-sectional area 0.01m2 and a velocity of 20 m/s strikes a plate and then flows in a plane parallel to the plate as shown in the figure below. The horizontal component of the force on the support is ....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution