Question Set

1. Compression members composed of two channels back-to-back and separated by a small distance are connected together by riveting so that the minimum slenderness ratio of each member between the connections, does not exceed





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The ratio of bases of a cylinder and a cone are in the ratio 3: Volume of cylinder and cone are in the ratio 9: then their heights are in the ratio?....
QA->The total number of members in the Legislative Council of a State shall not exceed __ of the total number of members in the State Legislative Assembly.?....
QA->A and B can do a work in 12 days B and C together can do it in 15 days and C and A together in 20 days. If A,B,C work together, they will complete the work in?....
QA->How much the time gap between two sessions of the Parliament should not exceed?....
QA->Distance between two stations A and B is 778 km. A train covers the journey from A to B at 84 km per hour and returns back to A with a uniform speed of 56km per hour. Find the average speed of the train during the whole journey?....
MCQ->Compression members composed of two channels back-to-back and separated by a small distance are connected together by riveting so that the minimum slenderness ratio of each member between the connections, does not exceed....
MCQ->The following observation relate to designing of laced column : 1. Single lacing systems on opposite planes shall preferably be in the same direction so that one is the shadow of the other. 2. Lacing bar should only be a flat. 3. The slenderness ratio of the lacing bars for compression shall not exceed 180. 4. Laced compression members are to be provided with tie plates of ends. Of these observations :....
MCQ->Which of the following are true about Legislative Council of a State:1. Its total number of members does not exceed two-thirds of total number of members in the Legislative Assembly of that State but is not less than 40. 2. One-third of its members are elected by the Legislative Assembly, one-third by local bodies, one-twelfth by teachers, one-twelfth by university graduates and one-sixth nominated by the Governor. 3. It cannot be dissolved. 4. One-third of its members retire every year.?....
MCQ->In a compression member, plate element may buckle locally before the entire member fails. To avoid this, which of the following recommendations are made ? 1. Thickness of members is taken in terms of lengths of compression members 2. Length of element is increased 3. Length of member is increased 4. Outstand is decreased Select the correct answer using the codes given below:....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution