Question Set

1. The maximum spacing of shear reinforcement should not exceed 0.75 d subject to a minimum of






Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->How much the time gap between two sessions of the Parliament should not exceed?....
QA->Where is the maximum difference in the spacing of longitudes?....
QA->The total number of members in the Legislative Council of a State shall not exceed __ of the total number of members in the State Legislative Assembly.?....
QA->Spacing between the boundary of the cell and the text inside the cell in a word table.....
QA->Decrease of viscosity with increasing shear rate is known as....
MCQ->The maximum spacing of shear reinforcement should not exceed 0.75 d subject to a minimum of....
MCQ->Consider the following statements with ragard to crack formation and its control: 1. The surface width of the crack should not, in general, exceed 0.30 mm for structures not subjected to aggressive environment. 2. When depth of web in a beam exceeds 750 mm, side face reinforcement @ 0.1 percent of web area should be provided on each face. 3. The nominal spacing of main bars in a slab should not exceed three times the effective depth of a solid slab or 300 mm, whichever is smaller. Which of the statements given above is/are correct ?....
MCQ->Consider the following statements : According to Bandura I. Reinforcement serves as an antecedent rather than a consequent influence II.Reinforcement functions as an informative and motivational operation III.Reinforcement does not function as a mechanical response strengthener IV. Direct reinforcement is not necessary in order for learning to occur. Of the statements :....
MCQ->Rivets and bolts subjected to both shear stress (τvf , cal) and axial tensile stress (σtf , cal) shall be so proportioned that the stresses do not exceed the respective allowable stresses τvf and σtf and the value of exceed does not exceed....
MCQ->Consider the following statements : 1. In a member subjected to uniaxial tensile force the maximum normal stress is the external load divided by the maximum cross-sectional area. 2. When the structural member is subjected to uniaxial loading, the shear stress is zero on a plane where the normal stress is maximum. 3. In a member subjected to uniaxial loading, the normal stress on the planes of maximum shear stress is less than the maximum. Of these statements :....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution