Question Set

1. The figure shows a rigid frame fixed at A and hinged at C. If a pure moment of 20 kNm is applied at B in the plane of the figure, then what is the moment at the fixed end A?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->In a certain code, "FOP" stands for "OLD IS GOLD", POT stands for "GOLD IS PURE" and POM stands for GOLD IS COSTLY. Then how will "PURE OLD GOLD IS COSTLY" be written?....
QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....
QA->Five equal forces of 10 N each are applied at one point and all are lying in one plane. If angles between them are equal, the resultant of these forces wil be?....
QA->John started from his home and walked 12 km.Then he took a right turn and walked 4 km.Then again,he took a right turn and walked 8 km and finally took another right turn and walked 1 km.How far is he from his home now?....
QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....
MCQ->The figure shows a rigid frame fixed at A and hinged at C. If a pure moment of 20 kNm is applied at B in the plane of the figure, then what is the moment at the fixed end A? ....
MCQ->Un-factored maximum bending moments at a section of a reinforced concrete beam resulting from a frame analysis are 50, 80, 120 and 180 kNm under dead, live, wind and earthquake loads respectively. The design moment (kNm) as per IS: 456-2000 for the limit state of collapse (flexure) is....
MCQ->The values of flexural rigidity EI and length L for the members AB and BC of the rigid frame ABC are equal.Joint B is rigid and the included angle between AB and BC at B is 900 Ends A and C are fixeWhen a moment of M is applied to the joint B,the rotation of the joint B is:....
MCQ->Two long columns C1 and C2 are made of the same materials. Column C1 has both the ends hinged while column C2 has one end hinged and other end fixed. What is the ratio of the critical load for C1 to that of C2 according to the Euler's formula ?....
MCQ->Ten new television shows appeared during the month of September. Five of the shows were sitcoms, three were hour-long dramas, and two were news-magazine shows. By January, only seven of these new shows were still on the air. Five of the shows that remained were sitcoms.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution