Consider the Schmitt trigger circuit shown below. A triangular wave which goes from - 12 V to 12 V is applied to the inverting input of the op-amp. Assume that the output of the op-amp moves from +15 V to -15 V. The voltage at the non-inverting switc ?->(Show Answer!)

Question Set

1. Consider the Schmitt trigger circuit shown below. A triangular wave which goes from - 12 V to 12 V is applied to the inverting input of the op-amp. Assume that the output of the op-amp moves from +15 V to -15 V. The voltage at the non-inverting switches between

Ask Your Doubts Here

Comments

By: guest on 02 Jun 2017 12.54 am

V0 is switching between + 15 to - 150 Thus voltage at non-inverting input switches between , 7.5 to - 7.5 .

Show Similar Question And Answers

QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....

QA->A man is facing East, then the turns left and goes 10 m, then turns right and goes 5 m, then goes 5 m to the South and from there 5 m to West. In which direction is he, from his original place ?....

QA->Which is electrical circuits used to get smooth de output from a rectified circuit called?....

QA->The thickness of certain ceramics changes when a voltage is applied across them this property is called?....

QA->The electronic circuit which works only on two voltage levels (0 and 1) is called?....

MCQ->Consider the Schmitt trigger circuit shown below. A triangular wave which goes from - 12 V to 12 V is applied to the inverting input of the op-amp. Assume that the output of the op-amp moves from +15 V to -15 V. The voltage at the non-inverting switches between ....

MCQ->To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met? Each end of the trunk link must be set to the IEEE 802.1e encapsulation. The VTP management domain name of both switches must be set the same. All ports on both the switches must be set as access ports. One of the two switches must be configured as a VTP server. A rollover cable is required to connect the two switches together. A router must be used to forward VTP traffic between VLANs.....

MCQ->Consider the following statements, regarding an OP AMP: All types of negative feedback reduce non-linear distortion.All types of negative feedback reduce the output offset voltage.Non-inverting (current and voltage) feedback increases the input impedance.Inverting (current and voltage) feedback decreases input impedance. Which of the above statements is/are correct?....

MCQ->A Schmitt trigger has VT+ = 2.0 V and VT– = 1.2 V. What is the hysteresis voltage of the Schmitt trigger?....

MCQ->One lamp cab be controlled from five location by using intermediate switches and two way switches .How many number of intermediate switches and two switches are require to control a lamp from 5 positions?....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution