Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
When liquid is pumped through cooling coil in a stirred tank reactor to cool. Which of the following is not correct? ?->(Show Answer!)
Question Set

1. When liquid is pumped through cooling coil in a stirred tank reactor to cool. Which of the following is not correct?





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The pressure at the bottom of a liquid tank does not depend on which area?....
QA->The velocity of flow of a liquid through an orifice at the bottom of a tank depends on the?....
QA->Transformers, Microphones, Induction coil, Generators, Motors, Induction coil work on the principle of?....
QA->A charge of current in neighbouring coil will induce (contribute) a voltage (emf) in a coil is termed as?....
QA->Which​ ​one​ ​of​ ​the​ ​following​ ​pairs​ ​is​ ​NOT​ ​correct?....
MCQ->When liquid is pumped through cooling coil in a stirred tank reactor to cool. Which of the following is not correct?....
MCQ->Two completely penetrating wells are located L (in metres) apart, in homogeneous confined aquifer. The drawdown measured at the mid point between the two wells (at a distance of 0.5 L from both the wells) is 2.0 m when only the first well is being pumped at the steady rate of Q1 m3/sec. When both the wells are being pumped at identical steady rate of Q2 m3/sec, the drawdown measured at the same location is 8, 0 m. It may be assumed that the drawdown at the wells always remains at 10.0 m when being pumped and the radius of influence is larger than 0.5 L Q1/Q2 is equal to....
MCQ->Assertion (A): In liquid system the ratio of change in liquid level to change in flow rate is called resistance of liquid flow.Reason (R): In liquid level systems the ratio of change in liquid stored in a tank to the change in head is called capacitance of tank.

....
MCQ->Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)....
MCQ->A water tank has one inlet, A and one outlet, B. A takes 5 hours to fill the empty tank, when B is not open and B takes 8 hours to empty the full tank, if the tank is three fifth full, how much time will it take to fill the tank completely when both A and B are opened simultaneously ?(in hours)....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution