Warning: implode(): Invalid arguments passed in /www/wwwroot/jobquiz.info/mdiscuss.php on line 336
The height of telescopic metric staff ?->(Show Answer!)
Question Set

1. The height of telescopic metric staff





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Average height of 10 students in a class is 150 cm. A boy of height 160 cm left the class and a boy of height 148 cm is admitted. Then what is the average height of the students in the class now?....
QA->Communicating with staff at all levels and ensuring every member of staff feels part of a forward thinking team is....
QA->The ratio between the radius and height of a circular one of volume 314 cm (cube) is 5:Its height is....
QA->Which country produced 127 lakh metric tones fish in 2010?....
QA->Air Force Administrative Staff College is located at?....
MCQ->The height of telescopic metric staff....
MCQ->Statement: "As our business is expanding, we need to appoint more staff." Owner of a company informs his staff. Assumptions: The present staff is not competent. More staff will further expand the business. Suitable persons to be taken as staff will be available.

....
MCQ->The crane provides a long-reach capacity by using the telescopic boom segment DE. The entire boom is supported by a pin at A and by the telescopic hydraulic cylinder BC, which can be considered as a two-force member. The rated load capacity of the crane is measured by a maximum force developed in the hydraulic cylinder. If this maximum force is developed when the boom supports a mass m = 6 Mg and its length is l = 40 and = 60°, determine the greatest mass that can be supported when the boom length is extended to l = 50 m and = 45°. Neglect the weight of the boom and the size of the pulley at E. Assume the crane does not overturn. Note: when = 60° BC is vertical; however, when = 45° this is not the case.....
MCQ->R.L.of a factory floor is 00,Staff reading on the floor is 62 ft.and the staff reading when the staff is held inverted with bottom touching the tie beam of the roof truss is 1016 ft.What is the height of the tie beam above the floor?....
MCQ->A dumpy level was set up at mid-point between pegs A and B, 80 m apart and the staff readings were 1.32 and 1.56. When the level was set up at a point 10 m from A on BA produced, the staff readings obtained at A and B were 1.11 and 1.39. The correct staff reading from this set up at S should be....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution