Question Set

1. Allowable average shear stress in an un-stiffened web for beams made of steel of grade 250 N/mm2 is :





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->The average salary of all the workers in a workshop is Rs. The average salary of 7 technicians is Rs.12000 and the average salary of the rest is Rs. How many workers are there in the workshop ?....
QA->The average of six numbers is x and the average of three of these is y. If the average of the remaining three is z, then....
QA->The average score of a cricketer for ten matches is 9 runs. If the average for the first six matches is 42, what is the average for the last four matches?....
QA->In trial average method, the average of 20 numbers is assumed to be The sum of deviations of the numbers from 24 is found to be What is the average?....
QA->The average monthly income of A and B is Rs. The average monthly income of B and C is Rs. 6250 and the average monthly income of A and C is Rs. What is the monthly income of A?....
MCQ->Allowable average shear stress in an un-stiffened web for beams made of steel of grade 250 N/mm2 is :....
MCQ->A shaft is subjected to a maximum bending stress of 80 N/mm2 and maximum shearing stress equal to 30 N/mm2 at a particular section. If the yield point in tension of the material is 280 N/mm2 and the maximum shear stress theory of failure is used, then the factor of safety obtained will be....
MCQ->Consider the following statements : For an over-reinforced (singly reinforced) rectangular RC section. 1. the lever arm will be less than that for a balanced section. 2. the maximum stress developed by steel would equal the allowable stress in steel. 3. the maximum stress developed by concrete would equal allowable stress in concrete. Of these statements :....
MCQ->A compound bar consists of two bars of equal length. Steel bar cross-section is 3500 mm2 and that of brass bar is 3000 mm2. These are subjected to a compressive load 100,000 N. If Eb = 0.2 MN/mm2 and Eb = 0.1 MN/mm2, the stresses developed are:....
MCQ->A mild steel bar of square cross-section 40 mm x 40 mm is 400 mm long. It is subjected to a longitudinal tensile stress of 440 N/mm2 and lateral compressive stress is 200 N/mm2 in perpendicular directions. E = 2 x 10-5 N/mm2, μ = 0.3. What is the approximate elongation of tht bar in the longitudinal direction ?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution