The uniform slender rod has a mass of 5 kg. Determine the magnitude of the reaction at the pin O when the cord at A is cut and = 90° ?->(Show Answer!)

Question Set

1. The uniform slender rod has a mass of 5 kg. Determine the magnitude of the reaction at the pin O when the cord at A is cut and = 90°

Show Similar Question And Answers

QA->PIN number എന്നതിൽ PIN ന്റെ പൂർണരൂപം....

QA->The mass of P4O10 that will be obtained from the reaction of 1.33 gram of P4 and 5.07 of oxygen is?....

QA->A substance that speeds up a chemical reaction without being consumed itself in the reaction....

QA->ഇന്ത്യയിലെ ആദ്യത്തെ കുട്ടിത്തേവാങ്ക് (Slender loris) സാങ്ച്വറി നിലവിൽ വന്ന സംസ്ഥാനം?....

QA->The Direct Tax Code (DTC) task force has recommended a major cut in corporate tax for both domestic and foreign companies. What is the newly recommended corporate tax rate for both domestic and foreign companies?....

MCQ->The uniform slender rod has a mass of 5 kg. Determine the magnitude of the reaction at the pin O when the cord at A is cut and = 90°....

MCQ->A cord wrapped around the inner core of a spool. If the cord is pulled with a constant tension of 30 lb and the spool is originally at rest, determine the spool's angular Velocity when s = 8 ft of cord have unraveled. Neglect the weight of the cord. The spool and cord have a total weight of 400 lb and the radius of gyration about the axle A is kA = 1.30 ft.....

MCQ->A 600 mm long and 50 mm diameter rod of steel (E = 200 GPa, α = 12 x 10-6/°C) is attached at the ends to unyielding supports. When the temperature is 30°C there is no stress in the rod. After the temperature of the rod drops to - 20°C, the axial stress in the rod will be....

MCQ->The crane provides a long-reach capacity by using the telescopic boom segment DE. The entire boom is supported by a pin at A and by the telescopic hydraulic cylinder BC, which can be considered as a two-force member. The rated load capacity of the crane is measured by a maximum force developed in the hydraulic cylinder. If this maximum force is developed when the boom supports a mass m = 6 Mg and its length is l = 40 and = 60°, determine the greatest mass that can be supported when the boom length is extended to l = 50 m and = 45°. Neglect the weight of the boom and the size of the pulley at E. Assume the crane does not overturn. Note: when = 60° BC is vertical; however, when = 45° this is not the case.....

MCQ->The small bridge consists of an 1,800-lb uniform deck EF (thin plate), two overhead beams AB (slender rods), each having a weight of 200 lb, and a 2,400-lb counterweight BC, which can be considered as a thin plate having the dimensions shown. The weight of the tie rods AE can be neglected. If the operator lets go of the rope when the bridge is at an at-rest position, = 45°, determine the speed at which the end of the deck E hits the roadway step at H, = 0°. The bridge is pin-connected at A, D, E, and F.....

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution