A turn buckle is used to connect two round rods subjected to tensile loading and requiring subsequent adjustment for tightening or loosening. ?->(Show Answer!)

Question Set

1. A turn buckle is used to connect two round rods subjected to tensile loading and requiring subsequent adjustment for tightening or loosening.

Show Similar Question And Answers

QA->John started from his home and walked 12 km.Then he took a right turn and walked 4 km.Then again,he took a right turn and walked 8 km and finally took another right turn and walked 1 km.How far is he from his home now?....

QA->Rahim travelled straight from point E to F at a distance of 5 km. From F he turned left and travelled 6 km and reached point G, there he took a left turn and travelled 5 km to reach point H. He took another left turn and travelled 2 km and reached point I. How far is he from the starting point ?....

QA->A cyclist goes 40 km towards East and then turning to right he goes 40 km. Again he turn to his left and goes 20 kn. After this he turns to his left and goes 40 km, then again turns right and goes 10 km. I-low far is he from his starting point ?....

QA->Which is the tree requiring minimum water for its growth?....

QA->The last word typed at the end of a page being repeated as the first word in the subsequent page is called:....

MCQ->A turn buckle is used to connect two round rods subjected to tensile loading and requiring subsequent adjustment for tightening or loosening.....

MCQ->Consider the following statements about provision of sag rods : 1. Sag rods reduce span length of purlin in the weak direction. 2. Sag rods are installed in the plane of the roof. 3. Ridge purlin is subject to vertical components of sag rods on either side of slope. Which of the statements given above are correct ?....

MCQ->Consider the following statements : 1. In a member subjected to uniaxial tensile force the maximum normal stress is the external load divided by the maximum cross-sectional area. 2. When the structural member is subjected to uniaxial loading, the shear stress is zero on a plane where the normal stress is maximum. 3. In a member subjected to uniaxial loading, the normal stress on the planes of maximum shear stress is less than the maximum. Of these statements :....

MCQ->The yield point in fatigue loading compared to that in static loading is less. The ratio of ultimate tensile strength to endurance limit of a material subjected to fatigue loading is....

MCQ->Statements: All rods are bricks. Some bricks are ropes. All ropes are doors. Conclusions: Some rods are doors. Some doors are bricks. Some rods are not doors. All doors are ropes.

Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions Question ANSWER With Solution