Question Set

1. When filing soft metals, the file teeth are clogged with minute particles of metal. The file should be cleaned by





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Minute pore found on the soft aerial part of plant especially the leaves are called?....
QA->Which pair of metals constitutes the lightest metal and the heaviest metal; respectively?....
QA->Which pair of metals constitutes the lightest metal and the heaviest metal, respectively?....
QA->Process of exchange of hotter particles to the neighbouring colder particles is known as?....
QA->A colloid formed between gas particles and liquid or solid particles?....
MCQ->When filing soft metals, the file teeth are clogged with minute particles of metal. The file should be cleaned by....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->While grinding,metal particles are get clogged into the grinding wheel.This process is called?....
MCQ->If T is the actual number of teeth on a helical gear and φ is the helix angle for the teeth, then formative number of teeth is written as....
MCQ->S1: Metals are today being replaced by polymers in many applications. P : Above all, they are cheaper and easier to process making them a viable alternative to metals. Q : Polymers are essentially a long chains of hydrocarbon molecules. R : Today polymers as strong as metals have been developed. S : These have replaced the traditional chromium-plated metallic bumpers in cars. S6: Many Indian Institutes of science and Technology run special programmes on polymer science. The Proper sequence should be:....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution