Question Set

1. Shift lock is pressed by:





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->പ്രകാശത്തിൻറെ Red Shift, Blue Shift എന്നീ പ്രതിഭാസങ്ങൾക്ക് കാരണം....
QA->On which side of the keyboard is the shift lock key located?....
QA->Future shock; Third wave; Power shift എന്നീ പുസ്തകത്രയത്തിലൂടെ പ്രസിദ്ധനായ അമേരിക്കൻ സാമൂഹിക ശാസ്ത്രജ്ഞൻ 2016 ൽ അന്തരിച്ചു. ആര്?....
QA->A place where clothes are washed and pressed....
QA->The store house of dried; pressed and preserved plant specimens is known as?....
MCQ->Two products are sold from a vending machine, which has two push buttons P1 and P2. When a button is pressed, the price of the corresponding product is displayed in a 7-segment display. If no buttons are pressed, '0' is displayed, signifying 'Rs' .0'. If only P1 is pressed, '2' is displayed, signifying 'Rs. 2'. If only P2 is pressed, '5' is displayed, signifying 'Rs. 5'. If both P1 and P2 are pressed, 'E' is displayed, signifying 'Error'. The names of the segments in the 7-segment display, and the glow of the display for '0', '2', '5' and 'E', are shown below. Consider push button pressed/not pressed is equivalent to logic 1/ 0 respectivelya segment a to g are considered as functions of P1 and P2, then which of the respectively. If segments a to g are considered as functions of P1 and P2, then which of the following is correct?....
MCQ->Shift lock is pressed by:....
MCQ->Refer to the keyboard encoder in figure (a). Sometimes when the 5 key is pressed, the system attached to the keypad does not respond. The 5 input on the 74147 is monitored with a digital storage scope while repeatedly pressing the 5 key, and the waveform in figure (b) is obtained; the P above the trace indicates the points at which the technician pressed the key. What is most likely wrong with the circuit?

....
MCQ->The simplest method of welding two pieces of metal together is known as pressure welding.The ends of a metal are heated to a white heat-for iron,the welding temperature should be about 1300C-in a flame.At this temperature the metal becomes plastic.The ends are pressed or hammered together,and the joint is smoothed off.Care must be taken to ensure that surfaces are thoroughly clean first,for dirt will weaken the weld.Moreover,the heating of iron or steel to a high temperature cause oxidation,and a film of oxide is added to the heated surfaces.For this reason,flux is applied to the heated metal.At welding heat,flux melts and the oxide particles are dissolved in it together with any other impurities which may be present.The metal surfaces are pressed together,and the flux is squeezed out from the center of the weld.A number of different types of weld may be used,but for fairly thick bars of metals,a vee-shaped belt should be normally employed.It is rather stronger than ordinary butt weld. The simplest way of welding two pieces of metal together is....
MCQ->The size of the lock is referred to as the lock granularity.....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution