electrical-engineering-alternating-current-and-voltage Related Question Answers

1. If the rms current through a 4.7 k resistor is 4 mA, the peak voltage drop across the resistor is





2. A pulse waveform has a high time of 8 ms and a pulse width of 32 ms. The duty cycle is





3. A 20 kHz pulse waveform consists of pulses that are 15 s wide. The duty cycle





4. If the peak of a sine wave is 13 V, the peak-to-peak value is





5. A sinusoidal current has an rms value of 14 mA. The peak-to-peak value is





6. A signal with a 400 s period has a frequency of





7. A sine wave of 15 kHz is changing at a faster rate than a sine wave with a frequency of





8. The average value of a 12 V peak sine wave over one complete cycle is





9. When a sine wave has a frequency of 100 Hz in 12 s it goes through





10. A sawtooth wave has a period of 10 ms. Its frequency is





11. Two series resistors are connected to an ac source. If there are 7.5 V rms across one resistor and 4.2 V rms across the other, the peak source voltage is





12. If a sine wave goes through 10 cycles in 20 s, the period is





13. A square wave has a period of 60 s. The first odd harmonic is





14. Sine wave A has a positive-going zero crossing at 45°. Sine wave B has a positive-going zero crossing at 60°. Which of the following statements is true?





15. A phasor represents





16. A sine wave with a period of 4 ms is changing at a faster rate than a sine wave with a period of





17. A waveform has a baseline of 3 V, a duty cycle of 20%, and an amplitude of 8 V. The average voltage value is





18. A sine wave with an rms value of 12 V is riding on a dc level of 18 V. The maximum value of the resulting waveform is





19. If the rms current through a 6.8 k resistor is 8 mA, the rms voltage drop across the resistor is





20. The average half-cycle value of a sine wave with a 40 V peak is





21. The duty cycle of a pulse waveform with a pulse width of 10 µs and a period of 100 µs is 25%.



22. The angular position of a phasor represents the angle of the sine wave with respect to a reference.



23. The designation rms means repetitions measured per second.



24. The unit of frequency is the hertz.



25. Average value of a sine wave is 0.707 times the peak value.



Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution