electronics-transistors-and-applications Related Question Answers

1. The signal voltage gain of an amplifier, Av, is defined as:


2. In a class B push-pull amplifier, the transistors are biased slightly above cutoff to avoid





3. The depletion-mode MOSFET





4. Three different points are shown on a dc load line. The upper point represents the





5. Which of the following conditions are needed to properly bias an npn transistor amplifier?





6. Often a common-collector will be the last stage before the load; the main function of this stage is to





7. In order for feedback oscillators to have any practical value, the gain has to be





8. To get a negative gate-source voltage in a self-biased JFET circuit, you must use a





9. If the drain, source, and channel of a MOSFET are all a p-type material, and it operates in both modes, this is an n-channel D-MOSFET.



10. A practical CE amplifier has the input on the base and the output taken off the emitter.



11. The maximum peak-to-peak output voltage in the given circuit is 15 V.



12. Base currents are usually small because of the physical construction of the thin and lightly doped base.



13. The beta of a BJT is the ratio of collector current to emitter current.



14. A certain amplifier has a voltage gain of 210. That gain expressed in decibels is 46.4 dB.



15. A decrease in base current of a CE amplifier causes the voltage measured between the emitter and the collector to increase.



16. In an n-type JFET, current will flow when a positive voltage is applied to the drain and a negative voltage is applied to the source.



17. An essential requirement of a feedback oscillator is a phase shift around the feedback loop of 360°.



18. The gate-source junction of a JFET must be ________ for proper linear operation.





19. The ___ oscillator takes advantage of the piezoelectric effect.





20. In order to sustain oscillations in a feedback oscillator, the gain should be _________ so the product of Av × B equals_______.





21. VCE approximately equals _______ when a transistor is in saturation.





22. The power gain (Ap) of any transistor amplifier circuit equals the ___________.





23. A(n) ___ has a conductive channel only when it is biased properly.





24. Fill up the blanks using suitable choice: Wash your hands ......... water.?





25. The collector current in a class A amplifier flows for ________ of the ac input signal.





Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution