301. The material generally used for cylinder sleeves is
302. When turning a corner,
303. The acid used in automobile battery is
304. The rolling resistance is because of the friction between the
305. The Diesel engine works on
306. The Second Battle of Panipat was fought between?
307. Which of the following archaeologists initially discovered Lothal site of Indus Valley Civilization?
308. When the piston is at T.D.C, the volume above the piston in the combustion chamber is the
309. The South West Monsoon normally reaches Kerala in .......?
310. The capital of Arunachal Pradesh?
311. The first discourse of Buddha at Deer Park in Sarnath is called?
312. When the engine speed increases, the ignition timing must be advanced.
313. The main cause for the change in engine oil viscosity is
314. The problems caused by the wheel imbalance are
315. The connecting rod lower end is connected to the relevant __________ of crankshaft.
316. An assembler is used to translate a program written in..........?
317. The forced-fed lubrication system means that the oil is delivered to the engine by
318. The connecting rod connects the piston and the
319. Valve overlap is the number of degrees of camshaft rotation during which
320. The engine's idling speed will increase by a slight degree immediately after a cold engine has been started. It will drop as the engine warms up. and it will eventually reach the standard level.
321. The component that is responsible for converting the rotation of the steering wheel into lateral motion is the
322. The crankcase dilution means
323. In which one of the following cases is the President of India not bound by the aid and advice of the Union Council of Ministers?
324. The indicated power of a four-stroke engine (in watts) is equal to (where P = Mean effective pressure in N/m2, L = Length of stroke in metres, A = Cross-sectional area of the piston in m2, and N = Speed of the engine in revolutions per second (r.p.s))