technical-drawing-dimensioning Related Question Answers
1. One way to evenly space dimensions on a drawing is to use the ________.
2. The ________ tool on the Dimension tool bar will place several dimensions at one time by using a selection box placed over several part features.
3. A circular arc is dimensioned in the view where you see its true shape by giving the value for its:
4. This is the total amount that the feature on the actual part is allowed to vary from what is specified by the dimension:
5. The ________ dimension tool will place the length of an angled line.
6. Placement of dimensions on a drawing is controlled by ________.
7. Baseline dimensions are referenced from a common geometric feature known as a ________.
8. Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point of crossing?
9. This is a thin solid line directing attention to a note or dimension and starting with an arrowhead or dot:
10. The maximum and minimum sizes of a feature are identified by a ________ tolerance.
11. This is a line terminated by arrowheads, indicating the direction and extent of a dimension:
12. In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in feet and inches:
14. Most mechanical drawings will include tolerance information in or near the drawing title block.
15. When designing mechanical devices, the designer must consider what the allowable variation in size between mating parts can be.
18. Where the decimal-inch dimension is used, a zero is not used before the decimal point of values less than 1.
20. When a finished part is measured, it may vary slightly from the exact dimension specified.
21. Tolerance issues are primarily a concern in manufacturing rather than in the design and drafting process.
22. Dimensions are given in the form of distances, angles, and notes only when using metric units.
23. The nominal size of a feature is the exact measurement of the feature after the tolerance has been applied to it.
24. Drawings are usually made to a scale, which is indicated in the title block.
25. A set of two mutually perpendicular datum planes is required for coordinate dimensioning.
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution