Question Set

1. If the main reinforcement of the slab is parallel to a T-beam, the transverse reinforcement at mid span of the slab is provided at least ......of main reinforcement





Ask Your Doubts Here

Type in
(Press Ctrl+g to toggle between English and the chosen language)

Comments

Show Similar Question And Answers
QA->Which mirror is to be used to obtain a parallel beam of light from a small lamp?....
QA->Which mirror is to be used to obtain a parallel beam of light from a small lamp ?....
QA->In which temple Sree Narayana Guru Installed a slab as idol with the words, “Sathyam’ (Truth), Dharmam (Ethics), Daya (Compassion), Sneham (love)”?....
QA->ബീം (BEAM-Bigelow Expandable Activity Module) എന്നാൽ എന്ത് ? ....
QA->പ്രകാശം അനുപ്രസ്ഥതരംഗങ്ങളാണെന്ന് (Transverse wave) തെളിയിച്ച ശാസ്ത്രജ്ഞൻ?....
MCQ->If the main reinforcement of the slab is parallel to a T-beam, the transverse reinforcement at mid span of the slab is provided at least ......of main reinforcement....
MCQ->A simply supported beam of span L carries a concentrated load W at its mid-span. If the width 'b' of the beam is constant throughout the span, then, when the permissible bending stress is 'f', the beam's mid-span depth will be....
MCQ->In a pre-stressed concrete beam of span 6 m and section 300 mm x 500 mm,the pre-stressing tendons are located along the longitudinal centroidal axis,with an effective pres-stressing force of 900kN.If the beam is subjected to a uniformly distributed load of 15 kN/m including the self weight of the beam,the top and bottom extreme fibre stresses in concrete at the mid span section are respectively....
MCQ->A fixed beam and a simply supported beam having same span and develop same maximum bending moment due to uniformly distributed load on entire span. What is the ratio of uniformly distributed load on fixed beam to that on simply supported beam ?....
MCQ->Consider the following statements with ragard to crack formation and its control: 1. The surface width of the crack should not, in general, exceed 0.30 mm for structures not subjected to aggressive environment. 2. When depth of web in a beam exceeds 750 mm, side face reinforcement @ 0.1 percent of web area should be provided on each face. 3. The nominal spacing of main bars in a slab should not exceed three times the effective depth of a solid slab or 300 mm, whichever is smaller. Which of the statements given above is/are correct ?....
Terms And Service:We do not guarantee the accuracy of available data ..We Provide Information On Public Data.. Please consult an expert before using this data for commercial or personal use | Powered By:Omega Web Solutions
© 2002-2017 Omega Education PVT LTD...Privacy | Terms And Conditions
Question ANSWER With Solution